Trango-broadband M5580M-FSU Bedienungsanleitung PDF herunterladen (Seite 19)

Using the HTTP Interface

Trango Broadband Wireless — M5580M-FSU (Atlas Fox) User Manual Revision 2 page 15

Chapter 4 Using the HTTP Interface

This section describes a few more basic concepts and how to establish a basic wireless link with the AP,

using the Browser (HTTP) Interface. This section addresses only the most basic steps in establishing a link in the

lab, or a bench-top environment. It is highly recommended that you read the Access 5830 Users Guide to gain

understanding of all important configuration parameters and procedures prior to deploying any wireless

equipment.

Configure Basic Parameters

Each SU must be set up with basic information to communicate with the AP. At a minimum the Base ID must

match the Base ID of the AP, the SU ID must match the SU ID in the AP.s SUDB, and the AP.s active channel

must exist in the SU.s AP Scan Sequence.

To set up the SU, complete the following steps:

1. Connect to the SU (see Chapter two “Getting Started”), and open the Configuration

page.

Open a browser session and type the IP address of the radio at the address bar of the browser. Default IP

address is 192.168.100.100.

3. Leave the User name field blank and enter read write or read only Password. Press or Click OK.

Default password is trango. After logging on, the system information screen will be displayed.

Figure 8

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 32 33

Keine Kommentare

Trango-broadband M5580M-FSU Bedienungsanleitung Seite 19